Drill down function not working flowjo 10
- #Drill down function not working flowjo 10 how to
- #Drill down function not working flowjo 10 trial
- #Drill down function not working flowjo 10 free
250 inch long at the right hand end of the work to produce a true diameter, set the cutting tool bit to the diameter and set the graduated collar to the right diameter.ĥ. The feed rate used depends upon the surface finish required.ģ. Set the lathe to the recommended speed and feedrate. It is good practice to home the cutting edge before you take a finish cut.Ģ.
#Drill down function not working flowjo 10 free
Check to see if the cutting edge of the tool bit is free from nicks, burns, etc. Factors such as the condition of the cutting tool bit, the rigidity of the machine and workpiece and the lathe speed and feedrate, may affect the type of surface finish produced.ġ. Finish Turningįinish turning on a lathe, which follows rough turning, produces a smooth surface finish, and cuts the workpiece to an accurate size. Re-adjust the depth of cut, if necessary. 250 inch, stop the lathe and check the diameter for size. Measure the workpiece and adjust the tool bit for the proper depth of cut.Ĩ.
#Drill down function not working flowjo 10 trial
Take a light trial cut at the right hand end of the workpiece for about. Tighten the tool post securely to prevent the toolholder from moving during the machining operation.Ħ. Move the tool holder to the left hand side of the compound rest and set the tool bit to right height to center.ĥ. 030 inch feed, depending on the depth of cut and condition of the machine.Ĥ. Set the lathe to the correct speed and feedrate for the type and size of the material being cut.Ģ. 030 inch of the finished size in a few cuts as possible.ġ. Workpiece is generally rough turned to within about. Accuracy and surface finish are not important in this operation. The operation of rough turning is used to remove as much metal as possible in the shortest length of time. Remember, for each thousandth depth of cut, the diameter of the stock is reduced by two thousandths. 030 inch, since the cut is taken off the circumference of the workpiece.ġ0. 060 inch to be removed, the graduated collar should be turned in. Turn the graduated collar half the amount of material to be removed. Measure the work and calculate the amount of material to be removed.ĩ. Move the cutting tool to the end of the workpiece (to the right side) by turning the carriage hand wheel.Ĩ. Stop the lathe, but do not move the crossfeed screw handle.ħ. 250 inch long at the right hand end of the workpiece.Ħ. Start the lathe and take a light cut about. Set the lathe to the correct speed and feed for the diameter and type of material being cut.ĥ. Move the tool post to the left hand side of the compound rest and set the tool bit to right height center.Ĥ. Use a right-handed turning tool if feeding the saddle in the direction of the headstock.ģ. To have the same diameter at each end of the workpiece, the lathe centers must be in line. A diameter should be cut to size in two cuts: an roughing cut and finishing cut. Many factors determine the amount of materials which can be removed on a lathe. Work that must be cut to size and have the same diameter along the entire length of the workpiece involves the operation of parallel turning. Workpiece is generally machined on a lathe for two reasons: to cut it to size and to produce a true diameter.